YZ 125 C----537-005982

Friday, January 09, 2009


Wednesday, November 05, 2008

YZ 125 Almost there


Friday, January 18, 2008

ID Numbers YZ 125 C


Friday, January 04, 2008

Friday, December 28, 2007

Thursday, October 25, 2007

Tuesday, September 11, 2007

Parts required

1. Spoke set front wheel.
2. Spoke set rear wheel
3. Forks front
4. LH clutch lever
5.Clutch cable
6. Front brake cable 483-26341-01-00
7. Rim front (DID)
8. Rim rear (DID)
9.Chain (DID)
10.Electrical system
11. Tyres
12.Cylinder and bore to 0.75 3rd over
13.Exhaust pipe
14.Brake pads front and rear
15.Clutch assembly
16.Kick starter
17.Spark plug
18.Side stand
19.Seat foam
20.Tank decals
21.Carbie clamps and carbie
22. Air filters
23. Engine oil
24.Front guard rear guard
25.Hand grips
26.Chain ajusters x 2
27. LH Side cover

Tuesday, September 04, 2007

Waiting on main seals

The YZ125 C engine is ready for assembly,all 6 bearings have been replaced.
Crankshaft has been checked and all is A1.
Engine has been paint stripped and prepared for paint.
Paint will be a 2pac black semi gloss.
New engine dampers and spacers are ready for assembly.
Front forks being sent for re chrome,new seals. All tube work will be done in house including clear coating.

Monday, August 27, 2007

Friday, August 24, 2007

Wednesday, April 25, 2007

DID Logo

Rim sizes
Front 1.60 x 21
Rear 1.85 x 18

YZ 125C DID Rims.

Here is a set of rims removed from a yz125c, they differ from later models, the side of the rim has a rased section of about 2.5 mm. Some also had the DID logo stamped on them.

Friday, December 01, 2006

Tuesday, November 28, 2006

(Click on image to enlarge)

YZ 125 C Foot pegs.

 Posted by Picasa

Friday, November 24, 2006

Frame Restoration.

Ok here we go.
The frame is quite good for its age.
List of repairs and checks.

1.Rear upper engine mounts broken of.Fabrication of new sections required.
This looks like a common fault.

2.Brake pedal hole wore out needs repair.

3.Side stand needs attention.(new bolt and nut and spring)

4.Foot pegs need checking for square and exsesive wear. new pegs required

5.Check all threads are not stripped or rusty(Tape and clean all)

6.Check side cover,seat rear guard bash plate and pipe for fitment.

7.Check swing arm piviot holes for correct size (new piviot bot required)

8.Check for any cracks or stress points.

YZ 125 on rotor.

  Posted by Picasa

Saturday, November 04, 2006

Project YZ 125 C

  Posted by Picasa

Monday, August 14, 2006

Close up of YZ125C tank Australia.

  Posted by Picasa

Right Hand view engine yz 125C

  Posted by Picasa

Detailed photos.

  Posted by Picasa

YZ 125C

prefix 537 Total produced 13943
White and red Australia and os
Black and yellow in the USA

Posted by Picasa
Posted by Picasa